#Blacklist mac address meraki how to
#Blacklist mac address meraki software
#Blacklist mac address meraki series

#Blacklist mac address meraki how to

This example illustrates how to configure a MAC-based filter through the CLI, in order to filter the client with a MAC address of chapter describes how to configure MAC-based authentication on the Arubacontrollerusing the WebUI. They can also use numbers in the expanded range of 1100 to 1199.

#Blacklist mac address meraki software

In Cisco IOS Software Release 12.3(7)JA, MAC address ACLs can use numbers in the range of 700 to 799 as the ACL number. The command syntax format of a standard ACL is access-list access-list-number Д¤8-bit-hardware-address 48-bit-hardware-address-mask This type of ACL can be referred to as a source IP address-based ACL. Standard ACLs compare the source address of the IP packets to the addresses that are configured in the ACL in order to control traffic. You can use standard ACLs to allow or disallow the entry of client devices into the WLAN network based on the IP address of the client. If you do not have a basic wireless connection, refer to Basic Wireless LAN Connection Configuration Example. This document focuses only on how to use the CLI in order to configure filters. Use the Command Lookup Tool ( registered customers only) to find more information on the commands used in this document.ДЄll the configurations in this document assume that a wireless connection is already established. In this section, you are presented with the information to configure the features described in this document.

If there is a large number of entries to add to an ACL, for instance when filtering a list of MAC addresses for the clients, use a switch in the network that can perform the task. Note:В The number of allowed entries on an ACL is limited by the CPU of the AP. You can use the CLI to configure these types of ACL-based filters on the AP: For information on how to configure filters through the GUI, refer to Configuring Filters. This document explains how to use ACLs to configure filters through the CLI. You can use either of these methods to configure the filters on the APs: Protocol-based filters provide a more granular way to restrict access to specific protocols through the Ethernet and radio interfaces of the AP. IP address and MAC address filters allow or disallow the forwarding of unicast and multicast packets that are sent to or from specific IP or MAC addresses. You can also enable filters to restrict traffic from users on the wired LAN. You can use different types of filters to filter traffic based on: Provide an additional layer of wireless security Restrict access to the wireless LAN (WLAN) network You can use filters on APs to perform these tasks: Refer to Cisco Technical Tips Conventions for more information on document conventions. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration.

The information in this document was created from the devices in a specific lab environment.

#Blacklist mac address meraki series

The information in this document is based on these software and hardware versions:ДЄironet 1200 Series AP that runs Cisco IOSВ® Software Release 12.3(7)JA1ДЄironet Desktop Utility (ADU) Software Release 2.5 The configuration of a wireless connection with use of an Aironet AP and an Aironet 802.11 a/b/g Client Adapter Prerequisites RequirementsД¬isco recommends that you have basic knowledge of these topics: This document explains how to configure access control list (ACL)-based filters on Cisco Aironet Access Points (APs) with use of the command-line interface (CLI).